Search results for "Configuration Interaction"
showing 10 items of 99 documents
Energy transfer in LH2 of Rhodospirillum Molischianum, studied by subpicosecond spectroscopy and configuration interaction exciton calculations.
2001
Two color transient absorption measurements were performed on a LH2 complex from Rhodospirillum molischianum by using several excitation wavelengths (790, 800, 810, and 830 nm) and probing in the spectral region from 790 to 870 nm at room temperature. The observed energy transfer time of ∼1.0 ps from B800 to B850 at room temperature is longer than the corresponding rates in Rhodopseudomonas acidophila and Rhodobacter sphaeroides. We observed variations (0.9-1.2 ps) of B800-850 energy transfer times at different B800 excitation wavelengths, the fastest time (0.9 ps) was obtained with 800 nm excitation. At 830 nm excitation the energy transfer to the B850 ring takes place within 0.5 ps. The m…
Multi-scale multireference configuration interaction calculations for large systems using localized orbitals: Partition in zones
2012
A new multireference configuration interaction method using localised orbitals is proposed, in which a molecular system is divided into regions of unequal importance. The advantage of dealing with local orbitals, i.e., the possibility to neglect long range interaction is enhanced. Indeed, while in the zone of the molecule where the important phenomena occur, the interaction cut off may be as small as necessary to get relevant results, in the most part of the system it can be taken rather large, so that results of good quality may be obtained at a lower cost. The method is tested on several systems. In one of them, the definition of the various regions is not based on topological considerati…
High excitations in coupled-cluster series: vibrational energy levels of ammonia
2004
The ammonia molecule containing large amplitude inversion motion is a revealing system in examining high-order correlation effects on potential energy surfaces. Correlation contributions to the equilibrium and saddle point geometries, inversion barrier height and vibrational energy levels, including inversion splittings, have been investigated. A six-dimensional Taylor-type series expansion of the Born–Oppenheimer potential energy surface, which is scaled to different levels of theory, is used to determine vibrational energy levels and inversion splittings variationally. The electronic energies are calculated by coupled-cluster methods, combining explicitly correlated R12 theory (which incl…
Vertical spectrum of ethene: uncontracted versus contracted correlation methods and the role of the adapted molecular orbitals
1998
Abstract Ethylene vertical excitation energies (VEE) below 9.5 eV have been calculated with the complete active-space singles and doubles configuration interaction self-consistent size-consistent dressing (SC) 2 CAS–SDCI. The mean of the absolute deviation from experiment for the calculated VEE are 0.14, 0.05 and 0.03 eV for three different molecular orbital (MO) sets tried. The results show that an uncontracted method and a realistic MO set avoid the difficulties present in the calculation of the strongly mixed Rydberg-valence 1B 1u states.
No-core configuration-interaction model for the isospin- and angular-momentum-projected states
2016
[Background] Single-reference density functional theory is very successful in reproducing bulk nuclear properties like binding energies, radii, or quadrupole moments throughout the entire periodic table. Its extension to the multi-reference level allows for restoring symmetries and, in turn, for calculating transition rates. [Purpose] We propose a new no-core-configuration-interaction (NCCI) model treating properly isospin and rotational symmetries. The model is applicable to any nucleus irrespective of its mass and neutron- and proton-number parity. It properly includes polarization effects caused by an interplay between the long- and short-range forces acting in the atomic nucleus. [Metho…
Full configuration interaction calculation of singlet excited states of Be3
2004
The full configuration interaction (FCI) study of the singlets vertical spectrum of the neutral beryllium trimer has been performed using atomic natural orbitals [3s2p1d] basis set. The FCI triangular equilibrium structure of the ground state has been used to calculate the FCI vertical excitation energies up to 4.8 eV. The FCI vertical ionization potential for the same geometry and basis set amounts to 7.6292 eV. The FCI dipole and quadrupole transition moments from the ground state are reported as well. The FCI electric quadrupole moment of the X (3)A(1) (') ground state has been also calculated with the same basis set (Theta(zz)=-2.6461 a.u., Theta(xx)=Theta(yy)=-1/2Theta(zz)). Twelve of …
Electron delocalization in mixed-valence Keggin polyoxometalates. Ab initio calculation of the local effective transfer integrals and its consequence…
2002
We present a quantitative evaluation of the influence of the electron transfer on the magnetic properties of mixed-valence polyoxometalates reduced by two electrons. For that purpose, we extract from valence-spectroscopy ab initio calculations on embedded fragments the value of the transfer integrals between W nearest-neighbor atoms in a mixed-valence alphaPW(12)O(40) polyoxowolframate Keggin anion. In contradiction with what is usually assumed, we show that the electron transfer between edge-sharing and corner-sharing WO(6) octahedra have very close values. Considering fragments of various ranges, we analyze the accuracy of calculations on fragments based on only two WO(5) pyramids which s…
Equation-of-motion coupled-cluster methods for ionized states with an approximate treatment of triple excitations.
2005
The accuracy of geometries and harmonic vibrational frequencies is evaluated for two equation-of-motion ionization potential coupled-cluster methods including CC3 and CCSDT-3 triples corrections. The first two Sigma states and first Pi state of the N2 +, CO+, CN, and BO diatomic radicals are studied. The calculations show a tendency for the CC3 variant to overestimate the bond lengths and to underestimate the vibrational frequencies, while the CCSDT-3 variant seems to be more reliable. It is also demonstrated that the accuracy of such methods is comparable to sophisticated traditional multireference approaches and the full configuration interaction method.
A theoretical determination of the dissociation energy of the nitric oxide dimer
1994
Multi-reference CI methods have been applied to determine the dissociation energy and structure of thecis-N2O2 molecule. The convergence of the theoretical result has been checked with respect to a systematic expansion of the one-electron basis set and the multi-reference CI wave function. The best calculated value, 13.8 kJ/mol, is in agreement with the experimental value, 12.2 kJ/mol. It has been obtained with an extended ANO-type basis set [6s5p3d2f], including the effect of the basis set superposition error (BSSE) in the geometry optimization, and additional effects, such as the electron correlation of core electrons and relativistic corrections, using the average coupled pair functional…
Analysis of the CIPSI/DCCI approach to characterize the HF AND F2 single bond
1990
Abstract The aim of the present work is to account for the main differential correlation contributions occurring during the bond breaking process of HF and F2 molecules in an accurate and inexpensive way. Starting from the dissociation-consistent configuration interaction (DCCI) scheme by Goddard and co-workers the corresponding contributions are evaluated within the framework reported by Malrieu and co-workers, namely configuration interaction by perturbation with multiconfigurational zeroth-order wavefunction selected by iterative process (CIPSI). In addition, the DCCI scheme has been improved by introducing the dispersion effects associated with the valence MOs adjacent to the bond. The …